Open Hub
Black Duck Open Hub

 Settings |  Report Duplicate

1
I Use This!
Inactive

Commits : Listings

Analyzed about 20 hours ago. based on code collected 1 day ago.
May 01, 2023 — May 01, 2024
Commit Message Contributor Files Modified Lines Added Lines Removed Code Location Date
- use YAW D to limit yaw jump effect
[email protected]
More... over 10 years ago
- little baro IMU tweak (http://www.multiwii.com/forum/viewtopic.php?f=8&t=4059&start=10#p41545)
[email protected]
More... over 10 years ago
- add 6DOF LSM330 sensor and Nano_Plane board
[email protected]
More... over 10 years ago
- baro Alt based on ground temp compensation (http://www.multiwii.com/forum/viewtopic.php?f=8&t=4059) + mirror tweak
[email protected]
More... over 10 years ago
- tunning of Althold adjustment with sticks (http://www.multiwii.com/forum/viewtopic.php?f=8&t=4058)
[email protected]
More... over 10 years ago
- SBUS center define (http://www.multiwii.com/forum/viewtopic.php?f=8&t=3957)
[email protected]
More... over 10 years ago
- use alt.EstAlt instead of BaroAlt
[email protected]
More... over 10 years ago
- fix I2C_GPS_SONAR
[email protected]
More... over 10 years ago
- move #define FAILSAFE_DETECT_TRESHOLD out of RX.CPP
[email protected]
More... over 10 years ago
- fix compilation error from r1561 for arduino.ide - new board definition for crius se v2.0 (http://www.multiwii.com/forum/viewtopic.php?f=8&t=4003)
[email protected]
More... over 10 years ago
- exactly one definition of VERSION + welcome message for arduino IDE users
[email protected]
More... over 10 years ago
+ tri servo params in lcd + MY_PRIVATE_DEFAULTS (http://www.multiwii.com/forum/viewtopic.php?f=8&t=3987) + lcd.config: reset to defaults
[email protected]
More... over 10 years ago
- correction of old remaining syntax
[email protected]
More... over 10 years ago
- small mod about annex650_overrun_count
[email protected]
More... over 10 years ago
- little approximation about z velocity based on baro
[email protected]
More... over 10 years ago
- only one baro mode : vario around a throttle deadband
[email protected]
More... over 10 years ago
- magHold is reset when arm is switched on (http://www.multiwii.com/forum/viewtopic.php?f=8&t=3910)
[email protected]
More... over 10 years ago
- fix typo in include filename (some OS/filesystems understand the difference between lower and upper case in filenames)
[email protected]
More... over 10 years ago
- fix att.angle[] syntax
[email protected]
More... over 10 years ago
- cannot arm is baro mode is on (http://www.multiwii.com/forum/viewtopic.php?f=8&t=3910)
[email protected]
More... over 10 years ago
- fixing a missing #include
[email protected]
More... over 10 years ago
- split Serial into Serial(core UART management) & Protocol
[email protected]
More... over 10 years ago
- zero out gyro yaw for pid.controller=2 (as suggested by SergioC, http://www.multiwii.com/forum/viewtopic.php?f=8&t=3862) - LCD.config : allow writing to other CSet (like copying) - LCD.telemetry : correct bargraph for longer armedtime - coptertest #8 for ESC_CALIB_CANNOT_FLY
[email protected]
More... over 10 years ago
- gyro & acc calibration accuracy (http://www.multiwii.com/forum/viewtopic.php?f=7&t=3880)
[email protected]
More... over 10 years ago
- no RC averaging for Spektrum & SBUS
[email protected]
More... over 10 years ago
- correct compilation for LED_FLASHER, PILOTLAMP, LANDING_LIGHTS
[email protected]
More... over 10 years ago
- add an include so that ESC_CALIB_CANNOT_FLY can compile
[email protected]
More... almost 11 years ago
- lcd.config: no yaw.D for pid.controller==1 + add amperage to MSP_ANALOG (as suggested by haydent, adapted for dev version layout) - lcd.telemetry: display remaining time, if armedtimewarning is set - lcd.telemetry: display remaining mAh, if capacity alarm treshold is set
[email protected]
More... almost 11 years ago
- correct MEGA_HW_PWM_SERVOS for tricopter in GUI
[email protected]
More... almost 11 years ago
- correct MEGA_HW_PWM_SERVOS for tricopter in GUI
[email protected]
More... almost 11 years ago